Big Bass
Bass notation is written an octave above what you hear
If you have started reading music on bass, you may have noticed something that does not add up. You play the note on the page, check it against a piano or a tuner, and the pitch you hear is lower than the pitch written. A full octave lower. Nothing is broken and you have not misread the clef. Bass parts are written one octave above their sounding pitch, and almost nobody tells beginners this.
This page explains the convention, gives the real sounding pitches of the four open strings with their frequencies, and shows where the same convention turns up on double bass and guitar. It also covers why tab readers never meet this problem and then run straight into it the first time they open a notated part.
Bass music is written one octave higher than it sounds. A written note sounds an octave lower. The direction only goes that way, never the other.
The rule, stated once and clearly
Bass guitar music is written in bass clef one octave higher than it sounds. The instrument sounds an octave lower than written. Both sentences say the same thing. The reference on transposing instruments puts it directly: double bass, bass guitar, guitar and contrabassoon all sound an octave lower than written.
So if you see a note on the ledger line just below the bass staff, the note you hear is an octave below that written pitch. The direction only goes one way. The sounding pitch is always lower than the written pitch, never higher.
Why the convention exists
It is about ledger lines. A clef only covers so much range before notes start stacking up on short lines above or below the five staff lines, which is slow and unpleasant to read. The transposing instrument reference describes exactly this situation: some instruments have ranges that do not sit well on the staff with any of the common clefs, so the music is written an octave away from where it sounds to avoid excessive ledger lines.
You can see the problem even with the convention in place. Yamaha's guide to reading bass sheet music notes that the open E, the low B on a five string and the high C on a six string still do not fit on or between the five lines, so they need ledger lines. Now imagine writing the whole instrument an octave lower than that. Most of a normal bass line would sit below the staff.
The double bass follows the same convention for the same reason, which is unsurprising given that the bass guitar is tuned the same way. The guitar does it too, in treble clef rather than bass clef. This is a family habit, not a quirk of the bass guitar.
What the four open strings actually sound like
Standard tuning on a four string bass is E, A, D and G from lowest to highest. The New Grove Dictionary of Music and Musicians, quoted in the Bass guitar reference, gives exactly that set, and notes the bass is usually tuned the same as the double bass, an octave below the four lowest guitar strings.
The frequencies below come from the standard piano key frequency table, in equal temperament with A4 at 440 Hz. A1 is exact at 55 Hz, being three octaves below A4, and G2 is 97.999 Hz, shown rounded in the table.
Each written pitch sits an octave above the one you hear. Written E2 is 82.41 Hz, a full octave above the 41.20 Hz you hear from the open E string. That gap between 41 Hz and 82 Hz is the whole confusion in one number.
| String | Sounds | Frequency | Written as |
|---|---|---|---|
| 4th (lowest) | E1 | 41.20 Hz | E2 |
| 3rd | A1 | 55.00 Hz | A2 |
| 2nd | D2 | 73.42 Hz | D3 |
| 1st (highest) | G2 | 97.99 Hz | G3 |
Where those written notes sit on the staff
In bass clef the five lines from the bottom up are G2, B2, D3, F3 and A3. The four spaces are A2, C3, E3 and G3.
At written pitch, the open E is E2, one ledger line below the staff. The open A is A2, the lowest space inside the staff. The open D is D3, the middle line. The open G is G3, the top space, just above the fourth line.
These are staff positions, not sounding notes. Play that middle line and you hear D2, not D3. We derived these positions from the standard bass clef pitches plus the octave convention rather than from one source, but they agree with Yamaha's point that the open E falls outside the five lines.
Tab has no octave problem, which is why this blindsides people
Tablature does not describe pitch at all. It describes positions. The Tablature reference calls it operationally based: it shows where and when to put a finger, and pitch is implied rather than written. Lines are strings, numbers are frets, 0 means open.
Because tab points at a physical place on a physical instrument, there is no octave to get wrong. A 0 on the bottom line is the open E string, and you never have to ask which E is meant. Yamaha's guide states the trade-off: tab on its own carries no information about rests, rhythm, note length or expression, although length symbols are sometimes printed above it.
So a player who learns entirely from tab can play for years without meeting the transposition. Then a band hands them a notated chart, and the octave offset appears out of nowhere with no explanation attached.
What it means in practice
Reading with a pianist from the same page. If a piano part and a bass part show the same note in bass clef, the bass sounds an octave below the piano. That is expected, not a mistake by either player. Arrangers rely on it.
Using a tuner. A tuner reports sounding pitch. Tune the low string and it is reading roughly 41 Hz, the sounding E1, not the written E2. If you check tuning against a reference frequency, use the sounding figures above.
Writing parts in notation software. Most programs treat bass guitar and double bass as octave transposing and handle the shift for you, so entering notes at written pitch gives correct playback. The failure mode is doubling up: pick a sample library already mapped an octave down and you get playback two octaves low. Check one note against a known pitch before trusting a whole part.
Transcribing from a recording. Work out the sounding pitch by ear, then write it an octave higher. Writing it at sounding pitch is the most common way beginners end up with a part buried in ledger lines.
The 8 under the clef
There is a way to mark the shift explicitly. An octave clef carries a small 8 below it, meaning the notes sound an octave lower than written. The Clef reference describes this for treble clef, and says that for double bass, bass guitar and contrabassoon some scores show an 8 beneath the clef. Theory textbooks describe the same marking: an 8 below means an octave lower, an 8 above means an octave higher. For guitar and bass it is often called 8vb, from the Italian ottava bassa.
Leaving the 8 off is conventional, not an error. The same reference notes that in tenor vocal writing the 8 is sometimes omitted while the notes are still sung an octave lower, and that older pieces use a plain treble clef with the expectation that tenors transpose anyway. Bass parts work the same way: a plain bass clef on a bass guitar part is understood to mean written an octave up, whether or not anyone prints the 8.
Practice varies between publishers and between countries. Educational and orchestral editions are more likely to mark it. Popular song books and chart parts usually do not. There is also a definitional wrinkle: the Harvard Dictionary of Music, cited in the transposing instrument article, holds that once an octave transposing clef is used the word transposition no longer strictly applies, because the clef itself now tells you the truth about the pitch. That is a tidy summary of why reference books disagree about whether the bass is a transposing instrument at all.
Questions
Does bass sound higher or lower than written?
Lower. Bass guitar sounds one octave below the written pitch, because the part is written one octave above the sounding pitch. The direction is always the same, so if you play a written note and hear something an octave down, that is the convention working correctly.
What are the real frequencies of the four open bass strings?
In standard tuning the sounding pitches are E1 at 41.20 Hz, A1 at 55.00 Hz, D2 at 73.42 Hz and G2 at 97.999 Hz, in equal temperament with A4 at 440 Hz. Those are the pitches a tuner hears. On the page they are written an octave higher as E2, A2, D3 and G3.
Is the bass guitar a transposing instrument?
In the notation sense, yes. The music is written an octave away from where it sounds, which is what octave transposing means. Reference works split on the wording. Some list bass guitar with the transposing instruments, and the Harvard Dictionary of Music takes the view that if an octave clef with a small 8 is printed, the term transposition does not strictly apply. The practical rule does not change either way.
Why do I never see this problem in tab?
Tab describes positions, not pitches. A line is a string and a number is a fret, so there is no octave left to interpret. The cost is that tab by itself tells you nothing about rhythm, rests or note length, which is why most players end up learning both systems.
Does guitar do the same thing?
Yes. Guitar is written in treble clef and sounds an octave lower than written, which is why guitarists hit the identical confusion. The double bass follows the same convention in bass clef. It is a shared habit across these instruments rather than something specific to bass guitar.
Should I write the 8 under the clef in my own parts?
You can, and it removes any doubt for a reader. You can also leave it off, which is normal and not an error, since a plain bass clef on a bass part is already understood to mean written an octave up. Conventions differ between publishers and countries, with teaching and orchestral editions more likely to print it than popular song books.
Sources: Transposing instrument (https://en.wikipedia.org/wiki/Transposing_instrument) for bass guitar, double bass, guitar and contrabassoon sounding an octave lower than written, for the ledger line rationale, and for the Harvard Dictionary of Music point about octave clefs. Clef (https://en.wikipedia.org/wiki/Clef) for octave clefs, the 8 beneath the clef on double bass, bass guitar and contrabassoon parts, and for the 8 being omitted while the transposition still applies. Piano key frequencies (https://en.wikipedia.org/wiki/Piano_key_frequencies) for E1 41.20344 Hz, A1 55.00000 Hz, D2 73.41619 Hz, G2 97.99886 Hz and E2 82.40689 Hz in equal temperament at A4 = 440 Hz. Bass guitar (https://en.wikipedia.org/wiki/Bass_guitar) quoting the New Grove Dictionary of Music and Musicians for the E1 A1 D2 G2 tuning. Tablature (https://en.wikipedia.org/wiki/Tablature) for tab being operationally based with pitch implied. Yamaha Music Hub (https://hub.yamaha.com/guitars/bass/a-bassists-guide-to-reading-sheet-music-and-tablature/) for bass clef being usual, the open E not fitting on the five lines, and tab lacking rhythm and expression information. Open Music Theory (https://viva.pressbooks.pub/openmusictheory/chapter/clefs/) and First-Year Music Theory, Minnesota State (https://minnstate.pressbooks.pub/firstyearmusictheory/chapter/clefs/) for the octave treble clef and the meaning of an 8 above or below a clef. Not verified: the staff positions given for the four open strings are derived from standard bass clef line and space pitches plus the octave convention rather than quoted from one source, though they agree with Yamaha on the open E falling below the staff. The statement that most popular editions omit the 8 is reported as conventional practice in these sources but is not backed by any survey or standards document, so the page says practice varies by publisher and country instead of giving a figure. Tuner behaviour is stated as a consequence of sounding pitch, not quoted from a tuner maker. Elaine Gould's Behind Bars (Faber Music, 2011) is the standard notation reference but its bass guitar entry could not be read online, so nothing is attributed to it. The Open Music Theory and Minnesota State pages refused automated fetching, so their wording here is paraphrase from search extracts rather than a direct read.